my girl
my girl
So, this is part 2 of the My Girl project. Where I will be doing some controversial stuff to My Girl.
I am planning to skin her then glass over this. This will make for a completely rigid hull and no water ingress from the bottom up. I’m using 150mm wide strips and plastic staples to hold it while the glue dries. So, pics so far attached.
This site is dedicated to the restoration of My Girl, a planing launch built in 1925 by Dick Lang. She is a square bilge vessel based on a design by W.H.Hand. Originally powered by a 6 cylinder 90hp Scripps engine she was capable of over 18 knots.
Skinning Transom and Port side
Monday, 30 October 2017