First day back in a while, I sanded the btm and chine so i could get the chine and transom seams taped up ready for the glass,  I cheated a bit and stapled the double bias tape in place, then epoxied over this.  I decided at this stage to glass half the transom.  I have finally figured out how to use peel ply, so i’ll see tomorrow if it worked.  Once this was done I decided to fill the open seams in the skeg. I tightened the bolts holding it on but no change, so i mixed a runny brew. and taped up the gaps, then poured it in. This also seemed to work, updates tomorrow.